Comments on: Voltec Installation – Charger wiring close-up http://s.co.tt/2011/06/07/installing-our-new-240v-level-2-voltec-charge-station-phase-ii/img_6788/ Babblings of a computer curmudgeon. Mon, 24 Sep 2018 20:21:45 +0000 hourly 1 http://wordpress.org/?v=4.1 By: Scott http://s.co.tt/2011/06/07/installing-our-new-240v-level-2-voltec-charge-station-phase-ii/img_6788/#comment-162 Tue, 27 Dec 2011 01:44:21 +0000 http://s.co.tt/blog/wp-content/uploads/2011/06/IMG_6788.jpg#comment-162 Hi Blair,

Just to clarify, I removed the receptacle and box before installing the charge station. I should have shown the back of the unit before it went into the wall, but there are 2 plastic knockouts on the back with threads behind them for screwing in a cable connector. I used MC cable, so there’s an MC connector screwed into the Voltec, and then the MC cable from the meter is attached directly to that. You can see the back of the cable connector where the #12 comes through the back in the picture.

In other words, there’s just the hole from the receptacle box behind the Voltec with the cable coming through. Fortunately I was able to position the Voltec to cover the hole, otherwise I’d have to get out the drywall mud. :)

Oh, and congrats on getting the charge station. The 4 hour charge time is great for keeping Sparky topped off on the weekends.

]]> By: Blair http://s.co.tt/2011/06/07/installing-our-new-240v-level-2-voltec-charge-station-phase-ii/img_6788/#comment-161 Tue, 27 Dec 2011 01:30:02 +0000 http://s.co.tt/blog/wp-content/uploads/2011/06/IMG_6788.jpg#comment-161 Hi Scott,
I’m going to be installing my Voltec this weekend. When you installed the receptacle where the #12 gauge wire comes in, did you put some sort of metal cover over it, or did you just mount the Voltec charger right over the receptacle? Does this even matter? Thanks!

]]> By: Scott http://s.co.tt/2011/06/07/installing-our-new-240v-level-2-voltec-charge-station-phase-ii/img_6788/#comment-18 Mon, 25 Jul 2011 14:23:13 +0000 http://s.co.tt/blog/wp-content/uploads/2011/06/IMG_6788.jpg#comment-18 Minimum circuit requirement is a 240V 20A, so #12 wire (which is what I used) or thicker. If you’re running it in a wall you could go with NM-B (Romex), but I used MC (metal-clad) because I was doing a long exposed run in the garage attic. Plus I like the extra protection.

]]> By: andrew http://s.co.tt/2011/06/07/installing-our-new-240v-level-2-voltec-charge-station-phase-ii/img_6788/#comment-16 Sat, 23 Jul 2011 18:10:04 +0000 http://s.co.tt/blog/wp-content/uploads/2011/06/IMG_6788.jpg#comment-16 I like the through the back wiring verses using conduit from below. What are the wire requirements?

]]>